how to use macrium reflect to upgrade ssd

Change the boot order of your computer to boot from the NVMe drive first.

Remove your SATA drive and mission accomplished! If you want to keep the SATA drive in your computer as a secondary drive, continue to step #6.

Once the cloning process is complete, turn your computer off. (For details on cloning using Macrium Reflect, check out this post.) When you’re at it, note if your current SATA drive uses an MBR or GPT partition for later troubleshooting.

Run the drive cloning software and clone the existing SATA drive to the NVMe drive.

After the installation, restart your computer. For older Windows, download and install the NVMe driver software for your SSD.

If you’re using Windows 10, skip to step #4.

Install Macrium Reflect (or any drive cloning software that you’re comfortable with).

It will boot into the SATA drive as it did before. Assemble the NVMe drive onto your computer using the M.2 slot or the PCIe slot (via an adapter).

Make sure your computer is turned off.

Windows in-place NVMe SSD Upgrade: Steps by steps I recommend the free version of Macrium Reflect. An NVMe PCIe adapter, only if your computer doesn’t have an NVMe M.2 slot.

For example, if you’re using a 1TB SATA drive that’s 30 percent full, a 500GB NVMe drive (or larger) will do. An NVMe solid-state drive: Get a drive of a significantly larger capacity than the total data on the SATA drive.You can use a desktop’s graphics PCIe slot for an NVMe SSD upgrade

How to use macrium reflect to upgrade ssd